Questions on gauge pod and dash?
#1
Hi,
If I order the Scoobymania gauge pod, is it available pre-cut, ideally with only two holes? If not is there a better pod? (I have looked at the chiark gauge site but just want to check this before ordering).
Also, has anyone fitted the carbon fibre dash kit from GGR? Is it any good? How difficult is it to fit? And how do I get prices from GGR? I can't find them on the web-site.
Thanks
Laurence
If I order the Scoobymania gauge pod, is it available pre-cut, ideally with only two holes? If not is there a better pod? (I have looked at the chiark gauge site but just want to check this before ordering).
Also, has anyone fitted the carbon fibre dash kit from GGR? Is it any good? How difficult is it to fit? And how do I get prices from GGR? I can't find them on the web-site.
Thanks
Laurence
#4
Hi Laurence
I daresay Scoobymania would cut it for you, but it's easy enough to cut yourself - measure twice, cut once . Just give Mike a bell, they're very helpful there.
Babber's comment is right: the standard pod does look best, but for 52mm gauges you need to start cutting it about. You also need to hack your dash about to fit it in the first place, so it isn't an "undoable" operation!
Cheers,
Nick.
I daresay Scoobymania would cut it for you, but it's easy enough to cut yourself - measure twice, cut once . Just give Mike a bell, they're very helpful there.
Babber's comment is right: the standard pod does look best, but for 52mm gauges you need to start cutting it about. You also need to hack your dash about to fit it in the first place, so it isn't an "undoable" operation!
Cheers,
Nick.
Thread
Thread Starter
Forum
Replies
Last Post
Brzoza
Engine Management and ECU Remapping
1
02 October 2015 05:26 PM