Knocklink fitting
11 November 2003, 10:17 AM
#1
Scooby Regular
Thread Starter
Join Date: May 2002
Location: Scotland
Posts: 2,148
Likes: 0
Received 0 Likes
on
0 Posts
I've just rebuilt my engine and had the BOSCH knocklink sensor to fit onto the block above no.4 cylinder. I got the correct bolt I was advised (M8 x 40mm) to fit in the tapped hole on the block. However I went to fit it on Friday and found out the hole is actually M10. Since the sensor hole is good for 8mm bolt, can any1 advise how they fitted their sensor. Thanks
11 November 2003, 10:35 AM
#2
Scooby Regular
Thread Starter
Join Date: May 2002
Location: Scotland
Posts: 2,148
Likes: 0
Received 0 Likes
on
0 Posts
Cancel that - just had another look at Stefans site & I've been looking in the wrong place....D'oh 
Now located correct hole and shall fit sensor tonight.
Now located correct hole and shall fit sensor tonight.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
JonMc
Subaru Parts
22
06 February 2016 09:50 PM
blockhead
Subaru Parts
19
07 November 2015 11:50 PM
matt12
Engine Management and ECU Remapping
4
14 September 2015 09:36 AM
