Cable routing from engine bay help needed please
#1
Scooby Regular
Thread Starter
iTrader: (4)
Join Date: Nov 2002
Location: Here and there
Posts: 1,919
Likes: 0
Received 0 Likes
on
0 Posts
Got my new babe today (P1), And sometime over the next week i`ll be fitting a knocklink and oil temperature+pressure sensor cabling. Now in my old car (MY99 UK Turbo) there was no air con so it was easy to get the cables into the cabin through that big rubber grommet, but as i now have air-con to contend with can i have your suggestions on the best place to run these 3 cables based on your experiences please?
Thanks in advance
Ab
Thanks in advance
Ab
#2
Scooby Regular
For the passenger side you can still use the grommet. Just remove the aircon drain pipe, run the cabes and re-fit. Easy peasy on my MY99 with aircon.
There's another grommet on the drivers-side below the brake fluid resevoir. I used that for my Knocklink, oil temp & oil pressure wires.
Pics on my website
Stefan
There's another grommet on the drivers-side below the brake fluid resevoir. I used that for my Knocklink, oil temp & oil pressure wires.
Pics on my website
Stefan
#4
Scooby Regular
Thread Starter
iTrader: (4)
Join Date: Nov 2002
Location: Here and there
Posts: 1,919
Likes: 0
Received 0 Likes
on
0 Posts
Hells teeth Stefan! you`ve been a busy lad! excellent site, didn`t even notice that grommet near the brake reservoir! Everything looks so much easier now. Thanks very much
Ab
Ab
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
BHPvstorque
Subaru Parts
4
14 September 2015 08:25 PM
robbie1988
Wanted
2
13 September 2015 09:25 AM
Scooby-Doo 2
Wheels And Tyres For Sale
1
09 September 2015 06:51 PM