Hi,
i'm after some help in how to fit a boost gauge to a 95 Wrx.
Where do i take the feed from and which is the best way to get the tube in to the car.

Any help would be great.

 

Take you feed by t-ing off of the middle pipe of the 3 together on the top of the inlet manifold, you can pass the pipe through the grommet in the bulkhead between the clutch and brake resevoirs

Stuart

 

Cheers for the help,
I have just had a look for the pipes & I think that I have found them.
As I don’t want to T into the wrong Pipe, Can any body please let me know where they lead?
At the moment the pipe on the left is the feed for my dump valve. Where does the middle one (the pipe I should T into) lead to and the one on the right?

 

The one in the middle feeds to the MAP sensor (on the front left suspension tower). This is the one to 't' into. I have a MY94 WRX so same engine type, i will try to get a pic for you tonight (don't quote me on that tho ).

Tony.

 

Hope this helps, the pipe you tee off is the centre one of the three shown in the picture above (bottom right) if you follow the pipe you can see where it attaches to the white pipe (to gauge), and you can just see where the white pipe goes through the bulkhead (top left)

Stuart

[Edited by sasim - 9/18/2002 7:31:24 PM]

 

Thank's for all the help, I'm going to try fitting it this weekend.
I will let u know how i get on.

Cheers