Cabling
#1
Hi Guy's
I'm planning to fit a set of 6" MB Quart components in my MY99, and will just be running them of a Kenwood Mask headunit. Is there any benefit in recabling the existing wiring running through the doors back to the headunit ?
If so, has anyone had any experience with this job ? Easy or bit of a bitch ?
I'm planning to fit a set of 6" MB Quart components in my MY99, and will just be running them of a Kenwood Mask headunit. Is there any benefit in recabling the existing wiring running through the doors back to the headunit ?
If so, has anyone had any experience with this job ? Easy or bit of a bitch ?
#2
Yes there's a benefit, and yes it's a swine to do.
Use 12AWG wire or thereabouts, and WD40 for lubrication. Use something stiffer as a pull through wire, such as mains single core wire.
Use 12AWG wire or thereabouts, and WD40 for lubrication. Use something stiffer as a pull through wire, such as mains single core wire.
Thread
Thread Starter
Forum
Replies
Last Post
Brzoza
Engine Management and ECU Remapping
1
02 October 2015 05:26 PM