Fitting uprated y pipe on newage?
#1
Scooby Regular
Thread Starter
Join Date: Apr 2010
Location: ednburgh
Posts: 441
Likes: 0
Received 0 Likes
on
0 Posts
Fitting uprated y pipe on newage?
Iv bought an upgraded y pipe and was thinking of fitting, is it easy enough to change on newage? How does intercooler come of? Will it produce running issues?
#2
Scooby Regular
iTrader: (4)
pretty easy just fiddly getting the pipes back onto the inlet and turbo when refitting.
Undo the clips on inlet and turbo and dumpvalve. remove to the bolts in the brackets each side and off it will come. As for running issues you will probably not notice a difference but it does help a bit with spool and is much stronger than the plastic one which like to split and deform. No need to map it lol.
Undo the clips on inlet and turbo and dumpvalve. remove to the bolts in the brackets each side and off it will come. As for running issues you will probably not notice a difference but it does help a bit with spool and is much stronger than the plastic one which like to split and deform. No need to map it lol.
#4
Scooby Regular
iTrader: (5)
Pretty simple to fit really, takes about 30-40 minutes. Just make sure everything is back where it belongs, you take care around the dv gaskets (That is if you remove it from the ic) and check then double check that the hoses are on correctly and tight. If you remove the pipe mounts from the underside of the ic make sure you use new gaskets too.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
Scott@ScoobySpares
Full Cars Breaking For Spares
7
14 December 2015 08:16 AM
blockhead
Subaru Parts
19
07 November 2015 11:50 PM