Reverse inlet pipe saving
Reverse inlet pipe saving
Was looking at measuring up plans for my reverse inlet setup and found a saving of about 75-80 cm in pipework. Over a normally rotated inlet manifold and FMIC setup.
Do you guys think this is a good saving that will justify the work, or just go with a normal FMIC setup?
I plan to use phelonic spacers to raise the inlet manifold also so I can keep my AC.
Do you guys think this is a good saving that will justify the work, or just go with a normal FMIC setup?
I plan to use phelonic spacers to raise the inlet manifold also so I can keep my AC.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
Dec 28, 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
Nov 18, 2015 07:03 AM