jimbobs

Hi guys, im looking to upgrade my turbo but don't really know where to start! I bought the car not really knowing much about it ie mods and stuff, thought it was just standard but after looking on ebay for some uprated parts then looking at the car I seem to already have a few good bits and bobs on it,! parts I know it has are as follows: 440 yellow injectors (think these are standard), Sti intercooler, 3" decat bellmouth and 3" straight through exhaust with rs*r backbox, forge dv and a pipercross induction kit!

it currently has a TD04L turbo! so what I want to know is what is a direct fit, reasonably priced turbo for my car? and do I need anything else! also from what parts I have, what bhp will it be at present? roughly? cheers

daiski

td05 is a straight swap, but maybe for mad power you should be looking at the VF range .

i take it the car is mapped to get the most out of your mods?

calum4492

don't know if its of any interest but I have an almost brand new garrett gt3582r
pm me if ur interested this came of my mr2 turbo so its really just a turbo and not a kit

boothydude

vf 28 is a ideal upgrade and a straight swap,good for about 340 ish

jimbobs

not sure, is there anyway of telling? thanks

jimbobs

anyone know if the above mentioned mr2 turbo will fit?

jimbobs

will have a look at these thanks, any pro's n cons on this turbo?

blackvenom

Use the search bar! But a vf28, vf34/35 would be my first choices

daiski

you can un clip the exhaust housing from the mr2s and use the scoobys me reckons but that could be a load of bollocks lol

JGlanzaV

iTrader: (3)

No the mr2 one wont fit, i believe it will need a different exhaust housing to suit.,

Standard positon turbos would be from - blouch, scooby clinic, turbo technics, andy forrest, and more

depends on the power you want, i run a standard position turbo technics s206 at 532hp.

but that is with a proper engine build etc. decide what power you want and build to that

calum4492

no my gt35 wont be a straight swap but just thought id say I had it because I didn't know what kind of power u wanted, it uses a t3 flange so ur mani would need same flange

YoungY25

iTrader: (5)

Vf35 is a good bet. Slightly quicker spooling than the 34 and good pull once it gets going. £250 will get you a good one

jimbobs

been offered a TD05 of someone local its off a 1995 wrx will this be a straight fit onto my car? thanks