IHI VF24 "Up grade" on 2000 classic ?
#1
Scooby Newbie
Thread Starter
Join Date: Oct 2012
Location: Devon
Posts: 29
Likes: 0
Received 0 Likes
on
0 Posts
IHI VF24 "Up grade" on 2000 classic ?
Have been offered a local vf24 for good money, But don't want
to buy it if there is not much more hp to be had over my TD04 ?
Car has a decat down pipe, and no other mods, Running 267hp after
a remap.
Thanks in advance
to buy it if there is not much more hp to be had over my TD04 ?
Car has a decat down pipe, and no other mods, Running 267hp after
a remap.
Thanks in advance
#3
Scooby Newbie
Thread Starter
Join Date: Oct 2012
Location: Devon
Posts: 29
Likes: 0
Received 0 Likes
on
0 Posts
Thanks for the reply Makes a nice change on here lol
Im just hoping not to have to go down the uprated fuel pump / fuel pressure regulator route
Not after big bhp just a bit more than I have now
Im just hoping not to have to go down the uprated fuel pump / fuel pressure regulator route
Not after big bhp just a bit more than I have now
#4
Scooby Regular
Join Date: Dec 2012
Location: England
Posts: 282
Likes: 0
Received 0 Likes
on
0 Posts
Use the oil feed bolt from the V24 too. I believe they're different. Nice turbo upgrade though. Also use the V24 restrictor pill in the wastegate to actuator pipework.
#5
Scooby Newbie
Thread Starter
Join Date: Oct 2012
Location: Devon
Posts: 29
Likes: 0
Received 0 Likes
on
0 Posts
Restrictor pill .................................... lol
Mine was losing me 20hp from being in the wrong place
Don't spoze you know what size ? I know mines 1.2mm
Mine was losing me 20hp from being in the wrong place
Don't spoze you know what size ? I know mines 1.2mm
Trending Topics
#9
Scooby Regular
Join Date: Oct 2010
Location: Kings Norton, birmingham
Posts: 1,094
Likes: 0
Received 0 Likes
on
0 Posts
#10
Scooby Regular
Join Date: Dec 2012
Location: England
Posts: 282
Likes: 0
Received 0 Likes
on
0 Posts
V24 uses a 0.9mm located in the wastegate tee pipe on the pressure outlet side. the Td04 would have a 1.2 mm in the same place. obviously you know it will need mapping once fitted .
#11
Scooby Newbie
Thread Starter
Join Date: Oct 2012
Location: Devon
Posts: 29
Likes: 0
Received 0 Likes
on
0 Posts
Mine was between the actuator and T pipe, Should be between the turbo
outlet and T pipe where it is now
So I will need a 0.9 pill to get it mapped correctly ?
outlet and T pipe where it is now
So I will need a 0.9 pill to get it mapped correctly ?
Thread
Thread Starter
Forum
Replies
Last Post