v3 heads how to rebuild
15 June 2013, 11:24 PM
#1
BANNED
Thread Starter
iTrader: (5)
Join Date: Nov 2009
Posts: 1,279
Likes: 0
Received 0 Likes
on
0 Posts
v3 heads how to rebuild
i have just got some v3 sti heads and they are in bits anyone no where the cam caps go ie in which order do they go in and what head left or right
16 June 2013, 11:50 AM
#2
They usually have an 'E' for exhaust or 'I' for inlet embossed on the cam caps and an arrow which is supposed to point towards the front (cam pulley end !) as far as I can remember ?
I don't think they have any markings as to which is for the left or right hand head though.
There are a lot of people on here who know far more than me so I prepare to stand corrected !
I don't think they have any markings as to which is for the left or right hand head though.
There are a lot of people on here who know far more than me so I prepare to stand corrected !
16 June 2013, 01:36 PM
#3
As TheVoices put above, cam caps are marked 2I,4I,2E,4E for the Left hand head and the arrow faces the front of the engine.
There is also a code stamped on the head ( top right on the left hand head cam cap side ) which matches the code on the caps as they are lined bored from the factory.
Mick
There is also a code stamped on the head ( top right on the left hand head cam cap side ) which matches the code on the caps as they are lined bored from the factory.
Mick
Thread
Thread Starter
Forum
Replies
Last Post
Brzoza
Engine Management and ECU Remapping
1
02 October 2015 05:26 PM