Hi Folks

I'm planning on getting a FMIC in the near future and ideally want to keep the OE Re-circ dumpvalve. After a bit of research I got in touch with Dawn to source one of Harvey's adaptor plates. However there was only classic fitments left.

Question is, could I just get a second had OE re-circ valve from a classic and run it on my blobeye? I can't find anyone/anywhere else that make these adaptor plates.

Cheers for any advise

 

Harvey (God rest his soul) sold me one for my new age and it is still sitting in my garage and never been fitted as I made a DIY one. Also the viper pipe they supply is not the right one for a re serc you need to order a 90 degree silicon pipe. Is yours a new age?

 

Sorry just seen its a blob and it will fit but not the classic re serc

 

Hi mate. Yep I have blobeye (2003) with a standard blob DV but could only get an adaptor plate for a classic. So wondered if I just bought a classic DV as well if would all work ok?

I didn't get any viper pipe? Literally just the adaptor plate?

Fancy selling me your newage adaptor plate and I can just sell this classic one on to someone else?

Cheers.

Stuart

 

I bought a newage adapter and then decided to buy a forged one so its never been fitted. Cost me 30 so £25 delivered and its yours mate.

 

The DV on mine sits roughly where it did, and feeds back into the inlet pipework, just before the throttle.
You need that piece of pipework, that's all.