Japspeed fmic owners please.....
#1
Scooby Regular
Thread Starter
iTrader: (5)
Join Date: Oct 2011
Location: Cambridgeshire
Posts: 947
Likes: 0
Received 0 Likes
on
0 Posts
Japspeed fmic owners please.....
Afternoon!
I have trial fitted my new japspeed fmic and fits nicely except it seems a bit loose on the right hand side as you look at the engine. There is a threaded hole welded to the pipe and there is a 90 degree bracket in the pack and an arm with a semi circle on the end. Where do they go please?
Thanks!
Adam
I have trial fitted my new japspeed fmic and fits nicely except it seems a bit loose on the right hand side as you look at the engine. There is a threaded hole welded to the pipe and there is a 90 degree bracket in the pack and an arm with a semi circle on the end. Where do they go please?
Thanks!
Adam
#3
Scooby Regular
iTrader: (51)
Join Date: Nov 2002
Location: MSOC
Posts: 7,439
Likes: 0
Received 0 Likes
on
0 Posts
The bracket screws into the pipe and mounts onto the inlet manifold, as for the C shaped bracket I think that is to hold an induction kit.
I haven't used either on my set up as its in tighter than a nuns chuff!!!
I haven't used either on my set up as its in tighter than a nuns chuff!!!
#5
Scooby Regular
Thread Starter
iTrader: (5)
Join Date: Oct 2011
Location: Cambridgeshire
Posts: 947
Likes: 0
Received 0 Likes
on
0 Posts
I thought it might go to inlet manifold but it didn't seem to line up with anything.
I've taken it off now to have it powder coated and to get some different hoses made up by SFS.... Once I have it back ill have a look.....thanks!
I've taken it off now to have it powder coated and to get some different hoses made up by SFS.... Once I have it back ill have a look.....thanks!
Thread
Thread Starter
Forum
Replies
Last Post
Brzoza
Engine Management and ECU Remapping
1
02 October 2015 05:26 PM