centre thrust and rear thrust block identification
#1
Scooby Regular
Thread Starter
centre thrust and rear thrust block identification
exactly as the title really
can you tell if the block is rear or centre thrust without stripping it down?
also how do you id scdb or cdb from outside other than the cross hatching i believe on the top but is this only on the early engines that are centre thrust?
cheers
can you tell if the block is rear or centre thrust without stripping it down?
also how do you id scdb or cdb from outside other than the cross hatching i believe on the top but is this only on the early engines that are centre thrust?
cheers
#2
Scooby Regular
iTrader: (1)
In general (but not always),
Center thrust will have 4 bolt/2 stud bell housing.
Rear thrust will have 6 bolt/2 stud bell housing.
SCDB will normally have S20C casting numbers.
CDB has cross hatching on oil filter housing and above the oil pump - center thrust from the factory unless converted to rear thrust at a later date.
Mick
Center thrust will have 4 bolt/2 stud bell housing.
Rear thrust will have 6 bolt/2 stud bell housing.
SCDB will normally have S20C casting numbers.
CDB has cross hatching on oil filter housing and above the oil pump - center thrust from the factory unless converted to rear thrust at a later date.
Mick
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
38
17 July 2016 10:43 PM
MH-Racing
Subaru Parts
18
18 October 2015 04:49 PM
Nige 84
General Technical
0
17 September 2015 03:44 PM