I've just fitted replacement discs and plates and was windering what the running in procedure was.
No launching and off boost or can I run full boost but no launching?
Cheers
James

 

100 miles run in on normal driving and then off you go

 

Cheers mate, normal driving as in keeping boost to a minimum?
Also to start with I couldn't select gears so I bled the system and adjusted the pedal.
It is biting very high ( not like on previous but the discs were knackered ), Gave it a run all seemed ok other than pulling away. Got home and I couldn't select gears again, re-adjusted and now I can select gears again.
The only thing i'm worried about is the master cylinder rod is near enough at the end of its thread at the pedal and there is no freeplay.

 

I ran myn on full boost for 100 miles as advised by AS performance just normal driving giving it the full throttle where and when possible and was advised after 100 miles you can use them however you wish. My pedal was adjusted in accordance but this was all done by the garage so not sure what they did to be honest.

 

Thanks again mate, I may bleed it again and see if the slave cylinder can be pushed further towards the fork.
One other thing I noticed was the return spring keeps falling off