Couple of questions just to clarify something.

tps sensor on the v1 has 4 wires the v3 has 3 wires, can I disguard the brown wire out of the way ?

the 5th Injector ontop of the v1 manifold, Can this just be disguarded also as the v3 doesnt run this.

I have everything else sorted just these two slight Niggles I just need answers too if possible.

cheers in advance

 

Wouldn't worry about the 5th injector, as there shouldn't be any wiring in the harness for it Rob. Also there shouldn't be a fuel feed for it on a V3, just leave it in situ, unless you're using the rails off the Phase 1?

No idea on the TPS though.

 

Cheers Micky, I'm still using the v1 loom on the engine & it's currently plugged in on the V1 manifold, so Just needed to clarify if I could just tie it up tidy in the loom out of the way on the V3

Using the v3 fuel rails so That clears that up nicely.

As for the throttle position sensor
There's a red, white, black & brown in the tps on the V1 But only a red, White & black on the V3

Be perfect if I can just remove the Brown wire out of the way.

 

Brown wire isn't needed bud

 

How did you wire the IACV? looking at this mod myself!

 

Awesome, Just what I wanted to here, cheers fella

 

Same electrical connection on the v3 as the v1 as I understand.