PLX Systems Help
15 December 2012, 07:08 PM
#1
Scooby Regular
Thread Starter
iTrader: (11)
Join Date: Feb 2011
Location: Newcastle upon tyne
Posts: 2,750
Likes: 0
Received 0 Likes
on
0 Posts
PLX Systems Help
Hi guys
Hoping for a solution
Plx systems DM6 vacuum module with IMFD-SS sensor module
followed instructions to the letter
We are getting ring LED cycle on ignition but no reading in centre panel ( total blank ) should display 14.5 even if not set up
Checked for bad fuse , but can't be that as the LED cycle , checked cables for kinks ( all ok ) checked voltage ul analog connecter output 3.3v
LL analog connector output 8v all ok & correct
Is it a faulty dm6 module ? Or a faulty sensor module ?
Or have I got something wrong
It's doin my head in , signd up to there customer service & FAQ website
Plx systems California , dropped a post , but on further inspection last post was September by a tek guy ( great )
Any help on this would be greatly app
Thanks in adv
Hoping for a solution
Plx systems DM6 vacuum module with IMFD-SS sensor module
followed instructions to the letter
We are getting ring LED cycle on ignition but no reading in centre panel ( total blank ) should display 14.5 even if not set up
Checked for bad fuse , but can't be that as the LED cycle , checked cables for kinks ( all ok ) checked voltage ul analog connecter output 3.3v
LL analog connector output 8v all ok & correct
Is it a faulty dm6 module ? Or a faulty sensor module ?
Or have I got something wrong
It's doin my head in , signd up to there customer service & FAQ website
Plx systems California , dropped a post , but on further inspection last post was September by a tek guy ( great )
Any help on this would be greatly app
Thanks in adv
Thread
Thread Starter
Forum
Replies
Last Post
crazyspeedfreakz
Wanted
17
05 October 2015 07:19 PM