Right I've managed to get a reverse inlet manifold a cut and weld one as mines a v1 there are 2 pipes on the bottom of the throttle body they don seem to have anything to do with the actual tb. Can I discard these on the fb and just link the 2 water pipes together via sumthing like a T-piece pic below
[IMG][/IMG]

2nd.... The throttle is hitting inlet can I cut this piece down a little to allow for full throttle
[IMG][/IMG]

 

yes cut them little pipes off completely and loop the water pipes together where they were on the crossover pipe,trim the throttle to suit away you go.