How much work is it to change one? Mine is rattling and touching the steering rack

 

It's one of those jobs that can go either way mate , easy if all the nuts come off or can reduce you too tears if studs decide to snap
You only know how it's gonna go when you do it

 

So best to get new studs before hand then.

 

Without a doubt mate , for what they cost it's well worth getting half a dozen
Give your old ones a good soak before you start , it will help + drill bit and tap Just in case one snaps
Don't forget this is worse case scenario
You may get a socket on em all and they fly off
Then jobs a good un

 

Are they likely to snap off in the headers? Maybe easier to change the whole lot?

 

No mate it's usually turbo end where the are subject to heat

 

Ok mate. Thanks for the info :-)