Changing my springs in blob sti. So last night sprayed all the nuts with wd40 any left them overnight. Tonight came back to do them one side came off easy. Other side the top bolt at the bottom came off fine but have a absolute nightmare with bottom nut!!!!!!!! Heated it up, shocked it, had long strong arm on it aswell! Carnt seem to get it free any help???

 

grind/cut it off and fit new bolt

 

Nut splitter or have you tried any sort of impact, air or other type???

 

Is it corroded?

What sockets are you using ? In my halfords pro set there are a small number of flat edged sockets - not sure of the exact name. These will be far better if the nut/ bolts are corroded as there is less chance of slippage.

Have you had a decent length breaker bar on it?

If your really stuck as said above get an angle grinder on the job- would be my last resort though personally .

 

Yehhh done all this. All the others came off easily. Just thie1 being a ****!! Don't really wana grind it

 

Some times theres little choice. I have a 3inch air grinder. Ideal for that sort of thing. Or as above a nut splitter.

A good breaker bar should shift it though

 

Yehhh might pick up a nut splitter tomorrow see if that works