hi,im running 18"X 7.5" et48 alloys with 215/35/18 tyres on my v4 type r.
the suspension setup is kyb agx adj shocks with tein springs.i am unfortunetely experiencing arch rub on fairly hard cornering.the car is obviously sitting too low as i have adjusted the shocks up quite stiff and its still hapening.
my options are fairly limited as i want to keep the wheels on,i was thinking maybe i could fit some standard springs back on to the kyb agx shocks to raise the ride height slightly? would this work or is the only way to fit coilovers? if not oe springs, is there anything else out there that will lower a very small amount? i think the tein springs im using lower the car approx 30mm front and rear which is obviously too much.
any ideas on the best way to go?
didnt really want to go for coilovers.....
thanks.

 

Roll the arches?

 

how much would that be? and where can i get it done?

 

also,what happens as regards to the plastic inner arch on the front as they seem to be rubbing this slightly?

 

Im in the same boat mate with 17"! got my wheels off a 2003 scooby, i put my orig sti springs on the rear to higher it a bit and even went for 205 with rubber still does it!

 

Camber bolts and arch rolling will be good for start.

Rolled arches cost around £150 and usually Arch Enemy can come to you as they come to us,here is website and there are contact for someone who this doing in your area

http://www.archenemy.co.uk/


Jura

 

they are not catching by alot,if i put a set of standard springs back on,would that not cure it? it would raise the car back up 30mm?

 

??