Hi all was just wondering is there a code i can put in my keypad to make it bleep when arming and disarming i think its been muted before i got the car it is a 1999 classic with a sigma alarm cheers

 

There is a code, but having the bleep on is illegal.

 

:Hi Mate, have a read of this,


To access this mode - turn on the vehicle ignition, press the remote button once, type one of the numbers
listed in the chart below, immediately turn off the ignition. The numbers will have the following effect:
Number Function
0 Last trigger isolation - allows the system to be set excluding any circuit giving a trigger signal
at the end of the settle time (i.e. allows the system to be set with a defective bonnet switch,
without “false alarming” until the switch can be replaced)
1 Turns off the bleeps only for the next time the system is armed (If bleeps turned on!)
2 Turn off ultrasonics only for the next time the system is armed (also possible by pressing the
Remote Key with the ignition on before arming)
3 Puts the system into valet mode (effectively freezing the passive immobilisation and any
other features such as auto arm when the vehicle goes in for service. System re-activated by
arming with the remote key).
4 Turn on auto-lock (an anti-hijack feature that locks the doors and boot when the ignition is
turned on)
5 Turn off auto-lock
6 Turn off bleeps every time system is armed or disarmed
(Turned off at manufacture to comply with legislation)
7 Turn on bleeps every time system is armed or disarmed

( Note: This will contravene current legislation)

The numbers are on the keypad in the glovebox,Hope this helps.

If you send me your email address i have a full list of features which a member on here sent me.
( Note: This will contravene current legislation)

 

hi thanks for all the advice ,my email address is j-logden@live.co.uk thanks again,im sure that the alarm was going off the other day and only the indicators were flashing is there a mute mode ,thanks again