Hi All

I have a blob eye 03 WRX STI and was wondering how to make the gear change light and sound work.

I have no clue how to set it up

Also have a SIMTEC remapped with Anti lag & launch control and was wondering how to use the launch control
There are 2 switches on the center consol right in Anti lag and I think the left is launch control but how do I use it ?

Any help would be great

Regards

Dex

 

Depends on how the simtek was set up, Speak to the mapper who installed it would be my advice.

Your clocks, The Rev(- +) button near your temp gauge, Turn it to the right and hold it there for a few secs, Then release it and the needle will move around the counter, Twist it left or right to raise or drop the warning, Then once you have set the rpm you want, It will show --(No sound) if you want the sound turn it to the right again and it will change from -- to On

 

Hey Gaz
just setup the gear change thing
it works mint
thanks mate

TSL mapped it so I will look about for contact info for those guys

Cheers again man

Dex