i have a good mechanical knowledge just wondered how easy it is to change clutch and is there any specail ways of doing it as heard something about using a 6mm bolt for something but cant remember what please advise.

 

how easy is it to remove drive shafts from box aswell

 

driveshafts are held in by double roll pins just use punch to drift out
6 mm bolt used to remove clutch fork pivot pin

 

....behind hex plug around the back of the starter motor.

 

to be fair i find it easier to pull engine out to do clutch ( engine out in about 40 mins ) just make sure you remove the allen bolt from behind starter and pull the clutch fork retaining rod out.

 

sounds a harder job but it is the prefered method of many, mine was done this way

 

cheers guys might hire a engine crane then

 

with the retaining fork do u put bolt back in once u put gearbox back on engine or before...

 

put the release bearing on fork then fit the slide bolt and retaining cap. then once engine bolted back in push fork towards rear of car to click release bearing in place.

 

cheers