Does anybody know the best place to run the vac pipe through the dash? Bought a cheap autoguage jobbie as i have no idea what its boosting at the mo, but want the vac pipe to look as neat as possible!

Thanks

 

Hi,

There is a rubber bung/grommet about an inch diameter in the bulkhead just underneath the brake master cylinder - I made a neat hole in it just large enough for the pipe & not too small to squash it and threaded the pipe through. Due to location was a bit fiddly to get back into place but a little grease on the edges helped.
Is a good place as can easlily route the pipe up through the dash with plenty places to secure it and also route it along bulkhead and O/S inner wing.

Hope this helps,


Oh, mine is a Classic so not sure if New Age has the same bung !