TYPE R WATER SPRAY
#2
Scooby Regular
iTrader: (2)
Join Date: Dec 2003
Location: United Kingdom
Posts: 384
Likes: 0
Received 0 Likes
on
0 Posts
Yes they should have it if the car is standard of course if someone has been changing things perhaps had a front mount intercooler fitted then they may have removed it. The inlet manifold on it would also have been red when new. Mine is silver as I had the engine out for a lot of work an decided just to have it recoated silver as opposed to the original red, again someone could have gone down that route.
#3
Scooby Regular
Thread Starter
Join Date: Feb 2011
Location: Sheffield
Posts: 233
Likes: 0
Received 0 Likes
on
0 Posts
yes its got fmic on it, the switch looks like it used to be there but is now blanked off. Ye i reckon someone must have painted it then. Thanks pal
#5
Scooby Regular
iTrader: (3)
Join Date: Aug 2000
Location: 1600cc's of twin scroll fun :)
Posts: 25,565
Likes: 0
Received 2 Likes
on
2 Posts
As Ron said, it could be a wrx type R, in which case you probably have ABS, no IC spray, lower rev range (7.5k red line and not 8k), 2 pot front brakes (they wont have subaru on them), single pot rear brakes (smaller front/rear discs), different interior, though check the code on the vin plate on the pass side suspension strut under the bonnet.
Tony
Tony
#7
Scooby Regular
iTrader: (3)
Join Date: Aug 2000
Location: 1600cc's of twin scroll fun :)
Posts: 25,565
Likes: 0
Received 2 Likes
on
2 Posts
No they did the wrx type r pretty much from 3-6, abs was an option in place of the ic water spray (the unit takes up the same spot), but confirm all the rest like the brakes, rev counter etc.
Tony
Tony
Trending Topics
#9
Scooby Regular
iTrader: (3)
Join Date: Aug 2000
Location: 1600cc's of twin scroll fun :)
Posts: 25,565
Likes: 0
Received 2 Likes
on
2 Posts
No the WRX doesnt have the dccd, you need to check the codes on the vin plate as i said before, you will know if its an STI or if its just had the cosmetic changes then
Tony
Tony
Thread
Thread Starter
Forum
Replies
Last Post