dooby-do

iTrader: (2)

ok people i am about to fit my oil pressure gauge but i have noticed that on the sender it has 2 attachments rather than 1, now were do the two connections on the sender go.i have added a few pics also once i remove the bolt from under the alternator it connects to the t,piece but im unsre as to were all the wires will go as the sender on the engine at the moment already has a wire on it. any help would be appriciated regards ben




also on the actuall gauge its self it has an S + - im guessin the + & - are live and negative but surely the red and black wires comin out will do
the same job so just need to no were the S goes im guessing thats sender

Jamz_

iTrader: (12)

Right the wires coming off the unit should be +12v direct feed +12v ignition and black ground.

And (i think) the + and - bolts will go to the sender unit wk and g terminals...

TBH this is a strange one, as ive not seen sender like that before