EJ25 crank + big/small end bearings into ej20 block
#1
EJ25 crank + big/small end bearings into ej20 block
hi folks i was wondering if someone could give me abit off advice. i am currently in posestion of a EJ25 crank + big/small end bearing and i was hopeing to be able to fit to my EJ20 block would this be possiable....
any advice on this would be appreciated thanks in advance
weedoz:~)
any advice on this would be appreciated thanks in advance
weedoz:~)
#2
Scooby Regular
iTrader: (2)
Join Date: Feb 2009
Location: Twickenham
Posts: 1,272
Likes: 0
Received 0 Likes
on
0 Posts
I am sure you are going to get a lot of good answers for this. I think they use a 2.5 crank in a 2.0 block for a 2.1 conversion etc. Like i say someone with a more solid answer should be around soon.
#4
The crank will fit but because of the longer stroke (79mm instead of 75mm), regular 2.0 pistons will sit 2mm above the block. You need to get pistons with the wrist-pin 2mm lower for them to fit correctly. Some aftermarket companies make them, unfortunately I don't have a link to any.
#6
to mark [weedoz]
orite mate its all good mate as ive put the crank in andv its bran new!!!! go on ma ***** som im gonnie finish the rebuild n gee yee a shout later
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM