Drill out the rivets ( 4 off ) and fit cover with supplied nuts and bolts.
A

 

How many intercoolers have you got? Nice post count bump.

 

Hi Kevin,

As said above, not sure if they actually come with instructions new, if they do they only tell you to drill out the old rivets, remove the black surround (as explained when we spoke last) and screw the new cover on top, with 4x screw head bolts and nuts. I'd go for st steel nuts and bolts.

Hows the car by the way. Sorry to hear about it, I was gutted for you, especially after the money you spent on it a few days before.


Muddy

 

the cars in the body shop at the moment, it was only cosmetic, apart from a bit of the bumper pierced the radiator.

the front bumper and bonnet needed resparying anyway, covered in stone chips.

still, no consolation.

i will see you at the track next week, i should have her back by then.

kevin
(Ford Fiesta Courtesy Car)

 

Hi Kevin,

Pleased to see its not too bad.

I did about the same on monday,ploughed into the back of a lorry half way up lindum hill in my dads P100 lost all the front end DOOOOOOO,could have done without that,had a sneezing fit and didn't see it.

 

I've just bought a 2nd hand Power Engineering intercooler cover for my MY99 turbo.



The cover didn't come with any fixings or instructions.

Has anybody got any fitting instructions ?

Thanks
kevin


[Edited by kevin stanton - 4/11/2002 10:31:29 PM]