Quick help pls!!
23 January 2011, 12:43 PM
#1
Scooby Regular
Thread Starter
iTrader: (27)
Join Date: Feb 2004
Location: Cheshire
Posts: 1,597
Likes: 0
Received 0 Likes
on
0 Posts
Quick help pls!!
Hi folks
Any ideas why engine is 1/4" from going back to the box? Clutch is in line an all fits on gearbox shaft but wont go in that last bit.
Any ideas why engine is 1/4" from going back to the box? Clutch is in line an all fits on gearbox shaft but wont go in that last bit.
Trending Topics
23 January 2011, 02:21 PM
#9
try cleaning the dowels up with abit of sandpaper bud they are a very tight fit sometimes , also the long dowel that holds the clutch fork in place is out still aint it? good luck mate
23 January 2011, 02:28 PM
#10
Scooby Regular
iTrader: (6)
Join Date: Oct 2010
Location: bathgate ,scotland
Posts: 346
Likes: 0
Received 0 Likes
on
0 Posts
did you fit a new spigot bearing as looks like maybe not entering it, maybe check end of shaft for burrs/damage etc which may stop it going into bearing
Thread
Thread Starter
Forum
Replies
Last Post