Standard re circ dump valve to replace hks.

Where do the two big pipes go?
I have a front mount intercooler.
A piece of alloy charge carrier near the rear of the engine
is where the hks one is fitted with just one big hose and 1 tiny hose.

Cheers

 

I assume its an early classic?

The fitting from your intercooler pipe goes to the fitting on the side of your dump valve, and the one on the bottom goes back to your inlet pipe (you should have a pipe running from your inlet towards your dump valve that will have a blanking plug in it at the moment).

 

Nice one mate.

 

No problem!

 

Anyone no what size hose will i need lol?
The pipe from the intercooler off the old HKS DV goes to the side of the original DV and this tube fits fine. I am missing the bottom hose to the inlet pipe.
Iv measured the dump valve at 35mm just wanna double check. oh and what size alloy join do i need to replace the alloy blank? Im sure the blank is smaller than 35mm

Cheers chaps