Cold air feed - fitting advice
#1
Scooby Regular
Thread Starter
iTrader: (23)
Join Date: Jan 2010
Location: Bedfordshire
Posts: 1,642
Likes: 0
Received 0 Likes
on
0 Posts
Cold air feed - fitting advice
Hi
I have a Hawkeye WRX and have just bought this:
http://www.kstech.biz/servlet/the-40...STI-big/Detail
Is fitting this simple? My concern is, when I remove the standard air box will exposed hole big enough for the new filter cone to fit through?
Thanks
Gez
I have a Hawkeye WRX and have just bought this:
http://www.kstech.biz/servlet/the-40...STI-big/Detail
Is fitting this simple? My concern is, when I remove the standard air box will exposed hole big enough for the new filter cone to fit through?
Thanks
Gez
Last edited by GezP; 05 August 2010 at 09:06 AM.
#2
Scooby Regular
iTrader: (2)
You'll probably have to install the filter separately by feeding it up through the wheel arch, so the arch trim needs peeling back. This can be done without removing the wheel.
It'll definately need a remap.
Given where you are, an appointment with Zen Performance or Dynamix would be advisable.
It'll definately need a remap.
Given where you are, an appointment with Zen Performance or Dynamix would be advisable.
#3
Scooby Regular
Thread Starter
iTrader: (23)
Join Date: Jan 2010
Location: Bedfordshire
Posts: 1,642
Likes: 0
Received 0 Likes
on
0 Posts
Thanks Butty, the car is already a Duncan baby. I'm was gonna try and do the fitting myself and the get Duncan to tweak. Now knowing it has to go through wheel linning I'll probably get Tim (used to be at Zen) to do it when he does the other things before the map tweak.
cheers for the heads up mate
cheers for the heads up mate
Thread
Thread Starter
Forum
Replies
Last Post
aaron_ions
General Technical
17
03 November 2021 11:07 AM
oilman
Trader Announcements
15
01 October 2015 11:55 AM