block skimming
23 February 2010, 08:37 PM
#2
The least amount you can get away with to clean up any distorsion/warp on the deck face.
Standard height of each block half is 201mm,and you need to measure them first to see if they have been skimmed in the past.
Subaru say the grinding limit is 0.004" on the block.
The EJ207 crank is a rear thrust design,so not a direct drop in.
ick
Standard height of each block half is 201mm,and you need to measure them first to see if they have been skimmed in the past.
Subaru say the grinding limit is 0.004" on the block.
The EJ207 crank is a rear thrust design,so not a direct drop in.
ick
Thread
Thread Starter
Forum
Replies
Last Post
bluebullet29
General Technical
9
05 October 2015 02:17 PM