Wiring loom adaption
#1
Scooby Regular
Thread Starter
iTrader: (21)
Join Date: May 2005
Location: Portsmouth
Posts: 768
Likes: 0
Received 0 Likes
on
0 Posts
Wiring loom adaption
I really need some help with a problem I've got fitting an engine. Basically I have a 97 uk 2000 turbo (the engine has the central coil pack) which has a noisey engine. I have bought an engine from another 2000 turbo but this one has the coil pack off centre to the right.
I have the original wiring loom for the engine but they are different connectors and the new engine has different sensors on the Inlet manifold
basically what I want to know is if there is any way to adapt this new loom to fit the connectors on the car
Thanks in advance
mark
I have the original wiring loom for the engine but they are different connectors and the new engine has different sensors on the Inlet manifold
basically what I want to know is if there is any way to adapt this new loom to fit the connectors on the car
Thanks in advance
mark
#3
Scooby Regular
Thread Starter
iTrader: (21)
Join Date: May 2005
Location: Portsmouth
Posts: 768
Likes: 0
Received 0 Likes
on
0 Posts
It's not that Simple unfortunately as the idle control valve is completley different, as are the connectors for the coil pack and what I assume is the throttle position sensor
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM