defi boost gauge
#1
Scooby Regular
Thread Starter
Join Date: Oct 2008
Location: co.louth,eire
Posts: 729
Likes: 0
Received 0 Likes
on
0 Posts
defi boost gauge
have defi bf gauges fitted in my car and simtek mapped to 1.5 bar but when i drive the car..the boost goes to max on the gauge and brings on the alarm!!!
any ideas???
any ideas???
#3
Scooby Senior
iTrader: (3)
Join Date: Jun 2006
Location: Slowly rebuilding the kit of bits into a car...
Posts: 14,333
Likes: 0
Received 0 Likes
on
0 Posts
You could have a loose boost hose to the wastegate actuator, mine was split.
I knew instantly because my Phormula knock alarm went off, and the Monaro went past me as I headed for the slip-road....
DON'T drive it at 2 bar of boost, you'll kill it ! Assuming it's not a fully forged engine build.
HTH
dunx
P.S. I did and it must have had 460 bhp..... for about ten seconds !
P.P.S. If you actually mean the alarm is going off at around 1.7 bar.... then read the manual, on-line if necessary....
I knew instantly because my Phormula knock alarm went off, and the Monaro went past me as I headed for the slip-road....
DON'T drive it at 2 bar of boost, you'll kill it ! Assuming it's not a fully forged engine build.
HTH
dunx
P.S. I did and it must have had 460 bhp..... for about ten seconds !
P.P.S. If you actually mean the alarm is going off at around 1.7 bar.... then read the manual, on-line if necessary....
Last edited by dunx; 31 January 2010 at 12:13 AM.
Thread
Thread Starter
Forum
Replies
Last Post