hi all
what is the best way to fit oil catch can?1 or 2 cans,1 can 2 breather filters or just one can and join all pipes up?
which pipes go were?
one pipe goes from air induction pipe to plastic tee,one pipe then goes to engine?the other to inlet manifold
then other pipe comes from air induction pipe to plastic pipe and think it goes to engine on other side? which need joining and which go to tank?
think might of confused it abit there

 

what size silicone hose will i need

 

Mark what will your car be doing and have you got any major mods???

1 is more than ample for most mate....I suggest you have a look at the Technical Topics Archive section under this "General Technical" there's a write up for a classic and a newage.

Good Luck.