Hi I need to remove these off my 2.5 to sell but normally would stick it in gear and foot on the brake to undo but can't do this due to engine not in the car. Anybody got any tips on how to remove them please

 

If the flywheel is still fitted you could jam that whist you undid the pulley bolts.

 

get somthing with a large flat head and place it between the fly wheel and one of the lugs at the top of the housing, might need qite a bit of force to remove the crank bolt as they tend to be tight!

 

impact gun?

 

Cheers guys, no flywheel on and not got an impact gun lol

 

Take it to Zak

 

Ha ha was tryin to give him a break lol will just take it there once rods and pistons turn up and all other bits to build! Just wanted to get the heads off to sell so I could take him just the block.

On my way now ian