Hi All

Started to rebuild my engine today to notice the notch on the rear thurst bearing does not fit into the conversion i had done, if possible could anyone send any pics if they have had the conversion done with bearings fitted.

Regards

Steve

 

Who ever did the machining on the crankcases should have put another pair of locating notches in too Steve.
You can do it yourself with a set of small file's to locate the mains but make sure you clean all the swarf out when done.





Hope this helps

Mick

 

Thanks for that Mick

What would you do send it back as rcm machinest done the work or carry the work out myself , quick question mick where did you get the pic from