I plugged my power fc in today and it will not start. I've a uk 97 turbo with the 3 plug ecu. The model serial no. is PFC GC8D-0018 and apexi part number 414-F002. Can any one help because I've been looking on google most of the day.

 

I could be totally wrong, But i believe you have to swap the cam and crank signal wires over

 

So I need the pin outs or ins for the ecu, Any one got them?

 

I've got the pin outs of the ecu, got them off jollygreenmonster. So i'll swap the wires over and post what happens.

 

you know it needs mapping etc.. not trying to get work just don't want it ending in tears..

Simon

 

That was me phoning you at 17:30 on friday. Is it right that I need to change just the two wires over for the ecu, I just need to make shore that the PFC works because I got to off ebay. About the mapping there's three of us that will need a map, 2 scoobs and a datsun, we were thinking of phoning you anyway.

 

no problem.

Simon

 

please help...I've change over the crank and cam sensor, crank+ with cam+, position- with position- and sensor with sensor. still not working have I ballsed it up.

 

What year is the car? What pins have you changed?

IS the commander powering up?

 

It's a uk turbo 97. changed the cam to the crank and the crank to the cam all so the position and sensor signal like for like. I have no commander, I can get one off my bro if needed, I just wanted the car to fire up to make shore that it works.

 

you need to move the fuel pump pin too or if just temp then ground it

 

this is just to make shore. the fuel pump relay control pin, connector B137 on terminal 3. so I can just ground it. there's a ground just under the ecu we'll that do