Hey guys,

Been looking at getting myself a Mocal Oil Cooler, however, I am being told that the sandwich plates don't allow for temp/pressure gauge send offs? As in there's no holes made to accomodate this?

Does anyone know of any sandwich plates which do allow this? I don't fancy running two sandwich plates, could get messy!

Regards

 

Its normally easier to plumb into the main oil gallerys on top of the block for the oil temp and pressure sender units and use the sandwich plate for the take-off for the oil cooler or filter relocation pipework.

Mick

 

Unfortunately that's not really an option. So am really looking for a sandwhich plate for oil coolers which allows this...

 

Anyone..

 

Buy an in-line adaptor....

dunx

 

What's one of those?