Injector rubber bits
#1
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: Jan 2006
Posts: 163
Likes: 0
Received 0 Likes
on
0 Posts
Injector rubber bits
Hi,
I'm looking for some rubber bits for the injectors/fuel rails on my MY00.
I'll need :
1. O-rings for injectors
2. Rubber parts that go inside the injector caps (I think they're D shaped)
3. Rubber donuts that sit between the rails and manifold
Would very much appreciate an idea of who might sell these, or certainly some Subaru part numbers would be very helpful.
Many thanks.
I'm looking for some rubber bits for the injectors/fuel rails on my MY00.
I'll need :
1. O-rings for injectors
2. Rubber parts that go inside the injector caps (I think they're D shaped)
3. Rubber donuts that sit between the rails and manifold
Would very much appreciate an idea of who might sell these, or certainly some Subaru part numbers would be very helpful.
Many thanks.
#4
Scooby Regular
iTrader: (1)
You are right on the change point, it's possible to get a late 00my New age just as it's possible to get an early 01my registered Classic...
I should have guessed from your description really, as New age cars do not run the top injector cap.
The part numbers for the seals are as follows:
Large "O" Ring for Injector = 16698AA060 - £6.33 ea from Subaru
Small "O" Ring for Injector = 16698AA050 - £6.33 ea
Injector Cap Seal = 16607AA040 - £5.56 ea
Rail to Manifold Seal = 16608AA020 - £6.80 ea
Hope This Helps
Phil
I should have guessed from your description really, as New age cars do not run the top injector cap.
The part numbers for the seals are as follows:
Large "O" Ring for Injector = 16698AA060 - £6.33 ea from Subaru
Small "O" Ring for Injector = 16698AA050 - £6.33 ea
Injector Cap Seal = 16607AA040 - £5.56 ea
Rail to Manifold Seal = 16608AA020 - £6.80 ea
Hope This Helps
Phil
#5
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: Jan 2006
Posts: 163
Likes: 0
Received 0 Likes
on
0 Posts
Phil,
Hope this helps? - You're a diamond! Couldn't have been a better reply! Thanks loads.
If I were to replace all the rubber, it'd cost me about £100 !!
I was looking to replace the whole lot as they're looking a bit tired, but I may just go for rail/manifold donuts for now and see how I get on.
Thanks again Phil, that's been a great help.
- Does anyone know of any other sources for equivalent alternatives?
Cheers
Hope this helps? - You're a diamond! Couldn't have been a better reply! Thanks loads.
If I were to replace all the rubber, it'd cost me about £100 !!
I was looking to replace the whole lot as they're looking a bit tired, but I may just go for rail/manifold donuts for now and see how I get on.
Thanks again Phil, that's been a great help.
- Does anyone know of any other sources for equivalent alternatives?
Cheers
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
hedgecutter
General Technical
3
25 September 2015 02:35 PM