standard headers
21 April 2009, 09:16 PM
#1
Scooby Regular
Thread Starter
Join Date: Jun 2007
Location: here
Posts: 374
Likes: 0
Received 0 Likes
on
0 Posts
standard headers
i want to remove the heatshield for mine as there is a vibration from one of them can i take the shield of without removing the headers or will i need to drop them any pointers thanx
21 April 2009, 09:37 PM
#3
If you're extremely lucky!
I removed the heat shelds from mine while they were off the car and hardly any of the bolts came off easily and I ended up cutting most of the sheilding off with a dremel. I can well imagine it being a pain while in situ but you never know your luck.
I removed the heat shelds from mine while they were off the car and hardly any of the bolts came off easily and I ended up cutting most of the sheilding off with a dremel. I can well imagine it being a pain while in situ but you never know your luck.
21 April 2009, 10:09 PM
#5
Scooby Regular
iTrader: (2)
Join Date: Aug 2008
Location: In the middle somewhere..
Posts: 515
Likes: 0
Received 0 Likes
on
0 Posts
I took mine off with the headers off, but put them back on with the whilst the headers where on.. its not too hard but use loadsss of wd40 and you should be ok.. and dont use bi-hex sockets as the will just slip off and you will ahve to cut the manifold off. Hope that helps
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM