Has anyone got ant detailed specs for the build of a linered 2.33 CDB that are 100% accurate?? So far have managed to find a few snippets of information but need more detailed information in order to get machining carried out and purchase the correct parts.

So far I reckon on the following:

EJ257 Crankshaft (79mm throw)
Steel Liners, ??mm Liner inside diameter / bore
98mm Forged Stroker Pistons
Standard length EJ257 H beam Rods?
Machining of block to take Liners
Machining of block to rear thrust crank

Info that I require is where to source the Liners (spec as well), have seen a diagram listed on here using a diesel liner, and info on machining the bores of the CDB to suit etc (basicly need specs to have the block machined perfectly)

So far just wanting answer/clues to get moving on this as block has been sitting around for a couple weeks and needs to get sorted. All the other questions will follow with about the ancillaries once I have bottom end built!

Grateful of any help,

Cheers

Andy T

 

Speak to Steve Whitson or any good builder should advise you

 

Thanks for that Fai17, got his number from Andy Forrest the other day, will give him a call and see what he comes up with.