Replacing Exhaust - cat back
19 January 2009, 03:24 PM
#1
Scooby Newbie
Thread Starter
Join Date: Dec 2005
Posts: 15
Likes: 0
Received 0 Likes
on
0 Posts
Replacing Exhaust - cat back
I have just bought Milltek rear box and center pipe, how easy is this to fit, presuming its a straight fit for the two existing silencers.
Its going on a WRX Wagon (2005)
I have never actually jacked the scooby up, so will i be ok putting it on 4 axle stands or do i just need to lift the rear up.
Thanks
Jas
Its going on a WRX Wagon (2005)
I have never actually jacked the scooby up, so will i be ok putting it on 4 axle stands or do i just need to lift the rear up.
Thanks
Jas
19 January 2009, 03:42 PM
#2
Scooby Regular
iTrader: (1)
Join Date: Oct 2003
Location: on the B Roads..
Posts: 1,957
Likes: 0
Received 0 Likes
on
0 Posts
very easy job.. Just put a Milltek on mine..
2 x 13mm spring bolts and 4 rubber hangers.. personally I just jack the front n/s and undo it from there.. 30min job.
2 x 13mm spring bolts and 4 rubber hangers.. personally I just jack the front n/s and undo it from there.. 30min job.
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
7
14 December 2015 08:16 AM
trapper2013
ScoobyNet General
6
30 October 2015 03:10 PM
Danny0608
Subaru
6
27 September 2015 02:16 PM
Danny0608
Subaru Parts
0
12 September 2015 02:59 PM