rear thrust OR centre thrust????????
Thread Starter
Scooby Regular
iTrader: (5)
Joined: Jun 2008
Posts: 1,423
Likes: 0
From: In The Garage Usually!!
rear thrust OR centre thrust????????
right guys can some 1 advice me in the differance in the 2? i need to know what crank is in mine? how do you tell them apart? its a 97 sti wagon
thankyou
thankyou
need to get it sussed so i can order parts tommorow. thanks for the help
If you have a 97my then you can be sure it's a centre thrust as Mick has stated.
Rear thrust cranks were not fitted until the introduction of the phase two engine in 1998.
Phil
Rear thrust cranks were not fitted until the introduction of the phase two engine in 1998.
Phil
Last edited by PeeVee; Jan 17, 2009 at 12:11 PM.
Centre thrust as standard on that year of car.
Unless it has a later phase 2 block or the block has already been machined to accept a rear thrust. To confirm you would ideally have to strip the bottom end.
Sorry to confuse matters.
Unless it has a later phase 2 block or the block has already been machined to accept a rear thrust. To confirm you would ideally have to strip the bottom end.
Sorry to confuse matters.
Thread Starter
Scooby Regular
iTrader: (5)
Joined: Jun 2008
Posts: 1,423
Likes: 0
From: In The Garage Usually!!
ok guys seem to be having some luck so far, crank is centre thrust, also bearings and so on seem to be cheaper than the rear thrust 1s?
good news with the crank,it will be fine with a polish and then a rebalance. cant wait now.
good news with the crank,it will be fine with a polish and then a rebalance. cant wait now.
Thread
Thread Starter
Forum
Replies
Last Post
