want to take air con out, engine i out due 2 rebuild so traced pipes through engine bay and they go into bulk head but have bolts so i could remove the piping work as it enters bulk head.

im assuming that would be ok as the pipe left in bulkhead just run to matrix

 

I just removed the A/C pipework (The bolts you speak of ) and put a couple of rubber bungs in the matrix holes in the bulkhead, although this is not necessary. Crack the pipework slowly as there maybe a little trapped pressure.

Hope this helps
Colin

 

hi jus wanted to make sure that if i remove the air con that it isnt goin to cause the ecu to play up if it is connected to it(i was under the impression it isnt) and its just a matter of taking out the components and pipework up to the bulk as you bothe have said, cheers