Block machining tech question?
14 December 2008, 05:13 PM
#1
Scooby Regular
Thread Starter
Join Date: Dec 2006
Location: Oxford- the shire
Posts: 1,281
Likes: 0
Received 0 Likes
on
0 Posts
Block machining tech question?
I had my 2.0l CDB machined to accept a v9 nitrided 2.0l crank, does this mean , bearing/thrust wise, it is ready to accept a 2.5 crank in theory?
14 December 2008, 05:44 PM
#3
Former Sponsor
iTrader: (20)
Join Date: Oct 2006
Location: 8.95 @ 168mph. Zero to 1KM 194.1mph
Posts: 1,150
Likes: 0
Received 0 Likes
on
0 Posts
It should be able to take the 2.5lt crank, but there are areas of the block that will/may need relieving to let the 2.5lt crank, and rods work safely.
14 December 2008, 05:54 PM
#4
Scooby Regular
Thread Starter
Join Date: Dec 2006
Location: Oxford- the shire
Posts: 1,281
Likes: 0
Received 0 Likes
on
0 Posts
Thanks mark, i suppose i am trying to find out, before starting to buy for the build, if i actually do need to get more machining to the block done or not?
Thread
Thread Starter
Forum
Replies
Last Post
bluebullet29
General Technical
9
05 October 2015 02:17 PM
Brzoza
Engine Management and ECU Remapping
1
02 October 2015 05:26 PM