just torqued my block down to check clearance, using plastigauge and some of the plastigauge hasnt been compressed, center of the bearings untouched, outer edges squashed. and the clearances are

1. 0.045
2. comes 3/4 accross the 0.045 band aprox 0.030
3. comes 3/4 accross the 0.045 band approx 0.030
4. comes 3/4 accross the 0.045 band approx 0.030
thrust bearing 5. comes 1/2 accross the 0.045 band approx 0.023

is this right, i followed the torque settings 47nm 10mm bolts and 25nm 8 and 6mm and correct order

doing it now, please help

 

no 1