A technical question.
#1
Scooby Regular
Thread Starter
Join Date: Dec 2006
Location: Oxford- the shire
Posts: 1,281
Likes: 0
Received 0 Likes
on
0 Posts
A technical question.
My engine is a v2 sti, i had a later 2.7 bar map sensor fitted, waiting for mapping , i understand that doing this can can make the car run rich, etc, until i gat it mapped.
I do not know when it started but now i get fault code 24 (idle valve) popping up, now, which is most likely to be the cause of this problem?, the 2.7 bar map sensor, or the actual idle valve at fault?
thanks for your help
I do not know when it started but now i get fault code 24 (idle valve) popping up, now, which is most likely to be the cause of this problem?, the 2.7 bar map sensor, or the actual idle valve at fault?
thanks for your help
Thread
Thread Starter
Forum
Replies
Last Post
aaron_ions
General Technical
14
25 September 2015 02:33 PM
StueyBII
ScoobyNet General
3
18 September 2015 12:34 PM