ok guys after searching the net for a long long time i've finally found out which wire is for what on the alarm i got my hands on they are as follows

1 - Blue - Interior light pin switches (neg)
2 - Blue/Red - Boot switch (neg)
3 - Green/Black - Low current programable output
4 - Green/Red - As above
5 - Black - Earth
6 - Black - Earth
7 - Orange - Ignition sense
8 - Red - 3a 12v
9 - Pink - Central locking (Configurable)
10 - Blue/White - As Above
11 - Black - Immobiliser circuit 1
12 - Black - Immobiliser circuit 1
13 - Black - Immobiliser circuit 2
14 - Black - Immobiliser circuit 2
15 - Red/Yellow - Indicator supply (15a)
16 - Yellow - Indicator output
17 - Yellow - Indicator output
18 - Green/Orange - Accessory output (neg during trigger)
19 - Green/White - Central locking (Configurable)
20 - Pink/Black - Central locking (Configurable)

can anyone tell me where i need to attach these wires??
i think i know most of them but can someone plz help me confirm this, the alarm is a sigma m30.

i know its thatcham approved before anyone says and if you aint gonna advice me how to wire it plz dont post as when i've asked various ppl on the net they just get up tight coz its a thatcham alarm

 

found this

https://www.scoobynet.com/security-1...king-wire.html

adam