head gasket help
#1
head gasket help
i have a 1994 wrx and the headgasket has gone, i did a combustion test on it and its offically blown. What is the going rate for the headgaskets to be done and roughly how many hours does it take?
thanks daz
thanks daz
#2
Scooby Regular
Join Date: Jul 2007
Location: bristol
Posts: 102
Likes: 0
Received 0 Likes
on
0 Posts
Did mine at home, cost about 350 for parts. This included headset (but had to buy uprated cometic head gaskets separate), thermostat , waterpump , cambelt and in actual working on the car time probably 20 - 30 hours. Your probably looking at 1k to do in a garage but i'm sure somebody will give you a more accurate quote shortly mate. Just pray your bottom end doesn't go like mine ( lots of £££££ )
#3
i hope not lol. has the engine got to come out as it looks that way? would you say 1k is a good quote as when i get prices i dont want to fall for a stupid quote lol. daz
#4
Scooby Regular
Join Date: Jul 2007
Location: bristol
Posts: 102
Likes: 0
Received 0 Likes
on
0 Posts
I raised the engine so that you can get the heads off easier, so no it doesnt have to come out but i'm sure it would be easier (if your lucky enough to have an engine crane). I think 1k would be a fair price.
#5
Scooby Regular
Join Date: Mar 2007
Location: The right side of 30psi
Posts: 539
Likes: 0
Received 0 Likes
on
0 Posts
Is definately worth having the bottom end checked, head gasket failure is often a sign of bottom end on it's way out, there is no point going through the expense of head gasket, when 3-4 months later the bottom end could go.
#6
Scooby Regular
iTrader: (14)
Join Date: Nov 2007
Location: Midlands
Posts: 602
Likes: 0
Received 0 Likes
on
0 Posts
API will do head gaskets for £700 plus vat I think which is £822 (mies an STI but think you should have the steel gaskets fitted anyway) .
As above though when mine was done I had some other work carried out as it was on the bench. ACL big ends and mains,rings, uprated clutch, oil pump, lightened flywheel, decat ect.
As above though when mine was done I had some other work carried out as it was on the bench. ACL big ends and mains,rings, uprated clutch, oil pump, lightened flywheel, decat ect.
Thread
Thread Starter
Forum
Replies
Last Post